Stock Removal Residual (Cycle952) - Siemens SINUMERIK 840D sl Operating Manual

Parameter Description
DI Continuous cut - (only for ∇)
Set machining area Set machining area limits
limits
Relief cuts Machine relief cuts (grayed out)
10.5.8

Stock removal residual (CYCLE952)

Function
Using the "Stock removal residual" function, you can remove material that has remained for
stock removal along the contour.
During stock removal along the contour, the cycle automatically detects any residual material
and generates an updated blank contour. For a G code program, for stock removal residual
material, "Yes" must be programmed. Material that remains as part of the finishing allowance
is not residual material. Using the "Stock removal residual material" function, you can remove
unwanted material with a suitable tool.
The "Stock removal residual material" function is a software option.
Procedure
Milling
Operating Manual, 05/2017, A5E40868956
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Stock removal residual material" softkey.
The "Stock removal residual material" input window opens.
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Value
0
No
Yes
Can be set in SD
545