Changing And Adapting A Simulation Graphic; Enlarging Or Reducing The Graphical Representation - Siemens SINUMERIK 840D sl Operating Manual

Switching a single block on and off
7.8

Changing and adapting a simulation graphic

7.8.1

Enlarging or reducing the graphical representation

Precondition
The simulation or the simultaneous recording is started.
Procedure
...
Milling
Operating Manual, 05/2017, A5E40868956
Press the <CTRL> and <S> keys simultaneously to enable and disable the
single block mode.
1. Press the <+> and <-> keys if you wish to enlarge or reduce the graphic
display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the size
of the segment.
- OR -
Press the "Details" and "Zoom -" softkeys if you wish to decrease the size
of the segment.
- OR -
Press the "Details" and "Auto zoom" softkeys if you wish to automatically
adapt the segment to the size of the window.
The automatic scaling function "Fit to size" takes account of the largest
expansion of the workpiece in the individual axes.
7.8 Changing and adapting a simulation graphic
Simulating machining
245