Notes On Installing Devices In The Rack; Environmental Protection - Fujitsu ETERNUS CS800 S6 User Manual

1.2.11 Notes on Installing Devices in the Rack

CAUTION!
Never lift the devices into the rack using the handles on the front panel.
l
For safety reasons, not more than one unit may be unlocked or pulled out of
l
the rack at a time, otherwise the rack may tip over.
This is illustrated by the following pictogram:

1.2.12 Environmental Protection

Environmentally-friendly product design and development
This product has been designed in accordance with the Fujitsu standard for
"environmentally friendly product design and development". This means that key factors
such as durability, selection and labeling of materials, emissions, packaging, ease of
dismantling and recycling have been taken into account.
This saves resources and thus reduces the harm done to the environment.
ETERNUS CS800
If necessary, have other people help you mount the individual
l
components in the rack because of the weight involved.
When connecting and disconnecting cables, observe the relevant
l
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied
with the corresponding rack.
Route cables in such a way that they do not form a potential hazard
l
(make sure no one can trip over them) and that they cannot be
damaged.
The rack must be connected to the power supply by an authorized
l
electrician approved by the local utility company.
If the rack model is integrated into an installation that draws power
l
from an industrial power supply network with an IEC309 type connector,
the power supply's fuse protection must comply with the requirements
for non-industrial power supply networks for the type A connector.
An ETERNUS CS800 configuration can carry a leakage current > 3.5 mA.
l
Therefore, a ground connection must be established before connecting
to the mains.
1.2 Important Information
21