Replication Problems; Temperature Problems - Fujitsu ETERNUS CS800 S6 User Manual

Hide thumbs Also See for ETERNUS CS800 S6:
Table of Contents

Advertisement

15.2.4 Replication Problems

The table below describes corrective actions for problems occurring with the replication.
Priority Level
The replication was paused,
but the replication is still in
process.
The replication was paused
and a Failure event was
generated in the Replication
Events page.
Replication was disabled while
a replication was in process
and the replication completed.
Enabled replication on a NAS
share and received the
following Event: No
destination host is
specified for
replication.
Able to enable and schedule
replication for NAS even
though no target IP
configured.
Table 27: Replication Problems

15.2.5 Temperature Problems

Temperature problems are generally caused by incorrect room temperature, poor air
circulation inside the ETERNUS CS800 rack or components, or a malfunctioning cooling fan.
Use the following procedure if a temperature problem is reported:
1. Check the ambient temperature of the room containing the ETERNUS CS800 system to
verify that the temperature falls within the specified range.
2. Inspect for adequate air circulation inside the rack. Some racks may provide
additional fans to improve air circulations. Check the fan for proper operation. Clean
ETERNUS CS800
Description
When you click Pause, the system will continue to
replicate the current tag or block of information in
process. The process of completing the current tag
replication can take up to 15 minutes to complete. Once
that tag has completed replication the system will pause
and wait to resume.
This is normal. When a replication is paused, a failure
event is generated on the Replication Events page. They
system will continue the replication when you click
Resume.
If you click Disable during a replication in process, the
system will complete the entire replication and then
disable replication on the system. The system will be
unable to replicate until you click Enable.
You must configure the target system prior to configuring
the source. If the target system is not configured first, you
will not be able to designate the replication target.
It is possible to enable and schedule a replication when a
target system has not been configured. The replication
will not start until a target system is configured.
15.2 Common Problems and Solutions
438

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents