Running The Getting Started Wizard; Login, Welcome, License Agreement - Fujitsu ETERNUS CS800 S6 User Manual

d. Select Use the following IP Address and then enter the following information:
e. Click OK.
f. Wait for the computer to set the IP addresses on the local computer.
6.3

Running the Getting Started Wizard

6.3.1

Login, Welcome, License Agreement

See "Supported Browsers" on page 122
supported by the ETERNUS CS800 Web GUI.
Proceed as follows:
1. On the notebook:
a. Open a supported Web browser.
b. Type 10.17.21.1 in the Address box.
Press <Enter>.
The Login page displays (see figure below).
If the Login page does not display, verify that you entered the correct IP
address (10.17.21.1) and that the network settings on the computer are
correct. Wait five minutes, then try again. If the Login page still does not
display, contact Fujitsu Technology Solutions.
ETERNUS CS800
Depending on the configuration you may need to reset the network
settings to their original state later. Therefore keep in mind or write
down the current settings before you make any changes.
IP address – 10.17.21.200
l
Subnet mask – 255.255.255.0
l
6.3 Running the Getting Started Wizard
for information about the browsers
102