Fujitsu ETERNUS CS800 S6 User Manual page 156

Figure 118: Replication Wizard: NAS Shares
Step 4: VTL Partition
1. Select a VTL partition in the Replication Settings for VTL Partitions section to manage
its replication settings (see
adding VTL partitions to the system, use the VTL Configuration Wizard (see
Wizard" on page
2. To configure the partition to replicate its data to another ETERNUS CS800 system, enter
the following information under Send:
a. Select the Enable replication for selected partition check box to enable replication
for the partition.
b. (Optional) Select the Enable Cartridge based replication to target check box to
enable Cartridge Based Replication for the partition, and then enter a Sync ID in
the box.
With Cartridge Based Replication, a cartridge is automatically replicated when it is
unmounted. After replication, the replicated cartridges are immediately available
on the target system.
The Sync ID is used to identify the target partition that will receive replicated data
from the source partition. The Sync ID must be identical to the Sync ID of the
target partition on the target system.
c. Select the check box for each replication target you want to replicate the partition
to. When the partition is replicated, its data will be sent to all selected targets.
3. To configure the partition to receive replicated data from another ETERNUS CS800
system, enter the following information under Receive:
a. (Optional) Select the Enable Cartridge based replication to this ETERNUS CS800
check box to enable Cartridge Based Replication for the partition, and then enter a
Sync ID in the box.
ETERNUS CS800
"Replication Wizard: VTL Partitions" on page
140).
8.5 Replication Wizard
157).For help
"VTL
156