Fujitsu ETERNUS CS800 S6 User Manual page 118

Dest Gateway
In addition, to enable communication with the target ETERNUS CS800 by means of the
l
gateway, you must add a second host route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify a second set of routing details for the replication
interface on the source ETERNUS CS800:
Destination
Dest Netmask
Dest Gateway
Figure 88: Interface Routing: Example 3
Backpanel Locations
The Backpanel Locations section at the bottom of the Network page displays a graphical
representation of the Ethernet ports as they appear on the rear of the system.
The diagram indicates the current bonding configuration and connectivity status for all
Ethernet ports.
Ports that are bonded together in an interface are shaded the same color.
l
A green border indicates a port is connected to a network.
l
A red border indicates a port is configured but is not connected to a network.
l
Click Update Port View to update the information on the diagram.
l
ETERNUS CS800
Use the IP address of the gateway (192.168.10.1).
Use the IP address of the gateway (192.168.10.1).
Use 255.255.255.255.
Use the replication IP address of the source ETERNUS CS800
(192.168.10.100).
6.3 Running the Getting Started Wizard
118