Fujitsu ETERNUS CS800 S6 User Manual page 20

This equipment has been tested and found to comply with the limits for a "Class
A" digital device, pursuant to Part 15 of the FCC rules and meets all
requirements of the Canadian Interference-Causing Equipment Standard ICES-
003 for digital apparatus. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in strict accordance with the instructions, may cause harmful
interference to radio communications. However, there is no warranty that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
l
Increase the separation between equipment and the receiver.
l
Connect the equipment into an outlet on a circuit different from that to
l
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu is not responsible for any radio or television interference caused by
unauthorized modifications of this equipment or the substitution or
attachment of connecting cables and equipment other than those specified
by Fujitsu. The correction of interferences caused by such unauthorized
modification, substitution or attachment will be the responsibility of the
user.
The use of shielded I/O cables is required when connecting this equipment to
any and all optional peripheral devices. Failure to do so may violate FCC
and ICES rules.
ETERNUS CS800
1.2 Important Information
20