Fujitsu ETERNUS CS800 S6 User Manual page 154

enter the following information under Source:
a. In the Source Hostnames or IP Addresses box, enter the hostname or IP address of
the system that will send the replicated data to the ETERNUS CS800.
You can specify up to 10 replication sources. To enter multiple sources, press
<Enter> after each entry.
b. In the Maximum Snapshots Per Share or Partition drop-down box, select the
number of snapshots to retain for each replicated ETERNUS CS800 (up to 32).
During scheduled or manual data replication, the ETERNUS CS800 receives a
snapshot from the source system. A snapshot contains all of the data necessary to
fully recover or failback a ETERNUS CS800 to the point in time when the snapshot
was saved.
3. Click Next to continue.
Figure 117: Replication Wizard: System
Step 3: NAS Share
1. Select a NAS share in the Replication Settings for NAS Shares section to manage its
replication settings (see
For help adding NAS shares to the system, use the NAS Configuration Wizard (see
"NAS Wizard" on page
2. To configure the share to replicate its data to another ETERNUS CS800 system, enter
the following information under Send:
a. Select the Enable replication for selected share check box to enable replication
for the share.
b. (Optional) Select the Enable Directory/File based replication to target check box
ETERNUS CS800
"Replication Wizard: NAS Shares" on page
134).
8.5 Replication Wizard
156).
154