Fujitsu ETERNUS CS800 S6 User Manual page 95

Appropriate labels should be already affixed to the cables or can be taken from
the section LAN Cabling (SCALE) of the label sheet, see
page
2. Connect the host interface adapters CA#1 of both DX100 controller modules to the
server:
Figure 69: FC connection between server and DX100 controller enclosure
a. CM#0 CA#1 port 0 has to be connected to the upper port of the PCI FC card in slot
2.
b. CM#1 CA#1 port 0 has to be connected to the upper port of the PCI FC card in slot
8.
Appropriate labels should be already affixed to the cables or can be taken from
the section FC Cabling (SCALE) of the label sheet, see
88.
3. If DX100 drive enclosures are available, connect them to the controller enclosure using
the SAS cables delivered together with the system.
CAUTION!
The sequence of the DX100 storage expansion modules must be observed
precisely when they are mounted and connected to each other, see
Front and Rear of the Storage Expansion Module" on page
system will not work and might get damaged.
The SAS cabling of the DX100 storage modules has to be prepared in the form of a so
called reverse cabling: The cabling chain behind CM#0 of the CE module goes from the
first to the last DE while the chain behind CM#1 goes from the last to the first DE.
ETERNUS CS800
88.
5.3 Cabling the ETERNUS CS800 S6 System
"CS800 Labelsheet" on
"CS800 Labelsheet" on page
"Labels on
77. Otherwise the
95