Fujitsu ETERNUS CS800 S6 User Manual page 303

After selecting an interface in the IP Address Table, the Routing Details
table below expands to display available routes (if any).
A maximum of 8 routes per interface are allowed.
2. If necessary, click the Show link to show the routing details table.
3. Click Add Route to add a route to the selected interface.
Or select a route to edit its settings.
4. Enter the following network information as provided by your network administrator:
Destination
Dest Netmask
Dest Gateway
The destination gateway of each route must match the subnet of at least
one configured IP address listed in the IP Address Table. If no match is
found, an error displays stating that the route's destination gateway is not
reachable.
In the example shown in
host on the 10.50.50.x subnet, you would enter 10.50.50.0 for destination
network, 255.255.255.0 for the destination netmask, and 10.20.20.1 as the
destination gateway.
5. Click Update to save the changes you made to the Routing Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
6. Click Delete to remove IP routing information for the selected interface. Or click Undo
to revert all current Routing Details changes to the last update.
Applying Network Settings
For network changes to take effect, you must apply the changes, finalize the confirmation,
and reboot the system. To apply all changed settings on the Network page to the ETERNUS
CS800, click Apply at the bottom of the page. Follow the prompts to confirm the changes
and reboot the system.
To revert all network settings to the initial state and undo all changes, click the
Reset button.
ETERNUS CS800
The destination network for the route.
The network mask for the route.
The gateway IP address used for outgoing traffic sent
from the interface to a host or client. (This is usually
not the same as the default gateway.)
"Network Configuration" on page
10.9 System
294, to reach a
303