Replication Wizard - Fujitsu ETERNUS CS800 S6 User Manual

8.5

Replication Wizard

The Replication wizard provides guided assistance for configuring the ETERNUS CS800 to
send replicated data to another ETERNUS CS800 system as part of disaster recovery plan.
The wizard can also help you configure the ETERNUS CS800 to receive replicated data from
another ETERNUS CS800 system.
Sources send replicated data, and targets receive replicated data. A target system can
receive data from up to 10 sources.
A source system can send data to up to two targets. Finally, one system can act as both a
source and a target.
Additional Information
For more information about working with data replication, see
l
340.
Use the Replication wizard (or the Configuration > Replication page) to configure
l
other ETERNUS CS800 systems that this ETERNUS CS800 is configured to send replicated
data to or receive replicated data from. You should configure a target system before
configuring source systems.
To begin the Replication wizard, on the Wizards menu, click Replication.
Step 1: About
1. Read the information about the wizard.
2. Click Next to continue.
At any time while using the wizard, you can click Previous to return to the
previous step.
Figure 116: Replication Wizard: About
Step 2: System
1. If data on this ETERNUS CS800 will be replicated to another ETERNUS CS800 system,
enter target information under Target (see
154).
ETERNUS CS800
"Replication" on page
"Replication Wizard: System" on page
8.5 Replication Wizard
152