Installing A Storage Module In The Rack - Fujitsu ETERNUS CS800 S6 User Manual

Completing installation
Figure 55: Sliding the server into the rack
1. Release the locking mechanism of both rails (1).
2. Push the server as far as it will go into the rack (2) until the Quick Release Levers
(QRL) engage (3).
Note that the QRLs are engaged properly on both sides.
CAUTION!
Be careful with your finger. You can pinch it if the QRL changes to the release
position.
5.2.2

Installing a Storage Module in the Rack

CAUTION!
Do not uninstall the drives that are installed by default or move them to any other
slot. Contact your sales representative or maintenance engineer if drives that are
installed by default need to be uninstalled or moved to another slot.
Attaching the Slide Rails to the Rack
The position of the 1HU support bracket is determined relatively to the base line of the
Storage Base Module.
1. Locate the positions of the screws and the M5 cage nut with the help of the following
figure.
ETERNUS CS800
5.2 Installing the components in the rack
84