Replication Configuration - Fujitsu ETERNUS CS800 S6 User Manual

Figure 175: Accent Page
To configure ETERNUS CS800 Accent:
1. To enable ETERNUS CS800 Accent, select the Enable Deduplication with Accent check
box.
Or to disable ETERNUS CS800 Accent, clear the Enable Deduplication with Accent check
box.
You cannot use ETERNUS CS800 Accent if you are currently using NetBackup
Accelerator or Optimized Synthetic Backups. If you are using Accelerator,
please make sure that Accent is not enabled. For more information on using
NetBackup Accelerator, see the ETERNUS CS800 Configuration and Best
Practices Guide for NetBackup from Symantec .
2. Click Apply.
Click the Change Encryption Type link to change the OST data encryption
type (see
To use ETERNUS CS800 Accent, you must install the Fujitsu Technology
Solutions OST Client Plug-in on the media server. For information about
installing the OST Plug-in and using ETERNUS CS800 Accent, see the ETERNUS
CS800 NetBackup and Backup Exec OST Configuration Guide .

10.5 Replication Configuration

The Replication Configuration page allows you to configure and manage replication
targets and allowed replication sources on the ETERNUS CS800. A source sends replicated
data to 1 or 2 targets, and a target receives replicated data from up to 10 sources. An
ETERNUS CS800 can act as both a source and a target.
ETERNUS CS800
"Data Encryption" on page 327).
10.5 Replication Configuration
251