Installing In A Rack - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 2 Installation

2.3 Installing in a Rack

WARNING
2.3 Installing in a Rack
This section explains how to install a power synchronized unit and an AC sensor unit in a rack.
Make sure to check
sensor unit in a rack. Also refer to the manual that is provided with the racks.
CAUTION
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Do Not
• Do not use a power cord that does not satisfy the specifications of the power
synchronized unit and the AC sensor unit. Doing so may cause failure, fire, or
electric shock.
"Safety Precautions" (page 9)
Do
• If the power synchronized unit and the AC sensor unit are installed or
disassembled other than as described in this manual, device failure or electric
shock may occur.
• The power synchronized unit contains delicate components, and should be
handled gently. Do not drop or knock the power synchronized unit against the
rack during installation.
• Install the blank panels provided with the rack where no other devices are
installed.
• Especially for an enclosed rack with doors, or when multiple devices are to be
mounted and running, it is important to realize that the temperature inside
the cabinet will be considerably higher than that of the room. Make sure the
rack internal ambient temperatures do not exceed the environmental
conditions for temperature described in
to do so may damage the power synchronized unit.
• When installing the power synchronized unit with other devices into the same
rack, the airflow of the device installed on and under the power synchronized
unit may interfere with each other and reduce the effect of device cooling.
Make sure to leave plenty of room between the devices if required. Failure to
do so may damage the power synchronized unit and lead to malfunction.
• Do not obstruct the air vents in the power synchronized unit.
35
Copyright 2017 FUJITSU LIMITED
before installing the power synchronized unit and the AC
"1.3 Specifications" (page 23). Failure
P3AM-8012-10ENZ0