1.2.7
Modules with Electrostatic-Sensitive Devices
Modules with electrostatic-sensitive devices are identified by the following sticker:
Figure 1: ESD label
When you handle components fitted with ESDs, you must always observe the following
points:
Switch off the system and remove the power plugs from the power outlets before
l
installing or removing components with ESDs.
You must always discharge static build-up (e.g. by touching a grounded object) before
l
working with such components.
Any devices or tools that are used must be free of electrostatic charge.
l
Wear a suitable grounding cable that connects you to the external chassis of the
l
system unit.
Always hold components with ESDs at the edges or at the points marked green (touch
l
points).
Do not touch any connectors or conduction paths on an ESD.
l
Place all the components on a pad which is free of electrostatic charge.
l
For a detailed description of how to handle ESD components, see the relevant
European or international standards (EN 61340-5-1, ANSI/ESD S20.20).
1.2.8
Notes on Cleaning the Devices
CAUTION!
Switch the device off and disconnect the power plugs from the grounded
l
shock-proof sockets.
Do not clean any interior parts yourself; leave this job to a service
l
technician.
Do not use any cleaning agents that contain abrasives or may corrode
l
plastic.
Ensure that no liquid enters the system. Ensure that the ventilation areas of
l
the device are clear.
ETERNUS CS800
1.2 Important Information
18