Fujitsu ETERNUS CS800 S6 User Manual page 288

When entering IP addresses, never use an address that is in a reserved IP address
l
range. To see a list of reserved IP address ranges, click the quick tip icon [?]
located near the IP address field.
4. In the Access Type drop-down box, select the access type for the community:
Get
Get/Set
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Deleting a Community
Delete an SNMP community if you no longer want the ETERNUS CS800 to belong to a group
of devices that are monitored by a common management station.
To delete a community, select the community and click Delete.
You can select multiple destinations to delete at once.
Test
The SNMP Test page allows you to send a test SNMP trap to verify that SNMP is correctly
configured on the ETERNUS CS800.
To access the SNMP Test page, on the SNMP page, click the Test tab (see
on page 288).
Figure 198: SNMP Test Page
ETERNUS CS800
Allows SNMP get operations.
Allows both SNMP get and put operations.
10.8 Notifications
"SNMP Test Page"
288