Fujitsu ETERNUS CS800 S6 User Manual page 252

Additional Information
For more information about data replication, or to perform data replication, see
l
"Replication" on page
If the ETERNUS CS800 is configured as a replication target and replication is performed
l
across a public network, with the source and target located behind NAT-enabled
routers, you must specify a NAT IP address for the ETERNUS CS800 on the Network
page (see
To access the Replication Configuration page, click the Configuration menu, and then click
the Replication tab (see
Figure 176: Replication Configuration Page
Tasks
Use the Replication Configuration page to perform the following tasks:
View information about configured replication target systems (see
l
on page
Add, edit, or delete a replication target (see
l
253,"Editing a Replication Target" on page
page
Pause or resume replication to a target (see
l
Target" on page
Configure a constant replication throttle (see
l
257).
View information about allowed replication source systems (see
l
CS800 List" on page
Add or delete an allowed replication source (see
l
page 259
Specify the maximum number of received snapshots to retain for each source (see
l
"Changing the Maximum Number of Snapshots" on page
ETERNUS CS800
340.
"Configuring Interface IP Addresses" on page
"Replication Configuration Page" on page
253).
257).
257).
258).
or "Deleting a Replication Source" on page
299).
252).
"Adding a Replication Target" on page
255, or "Deleting a Replication Target" on
"Pausing or Resuming Replication to a
"Enabling System Throttling" on page
"Source ETERNUS
"Adding a Replication Source" on
260).
260).
10.5 Replication Configuration
"Target System List"
252