Fujitsu ETERNUS CS800 S6 User Manual page 113

IP Address
Netmask
Gateway
5. If necessary, specify NAT (Network Address Translation) settings for the interface:
If the ETERNUS CS800 is a replication target and is behind a NAT router, you
must configure a NAT IP Address.
NATed
NAT IP Address
6. Select the check box for each type of network traffic allowed on the interface
(segmentation):
At least one interface must allow management traffic.
Mgmt Select to allow management traffic.
Repl
Data
Any
Additional Information
If the ETERNUS CS800 is configured for source or target replication, you should
l
configure at least one interface to allow replication traffic (select Repl or Any)
before applying changes to network settings.
If you configure segmentation for non-bonded interfaces (Ethernet ports) that are
l
on the same subnet, all traffic will use the lowest numbered Ethernet port first, no
matter how segmentation is configured. To avoid this issue, create bonded
interfaces, and then select the desired traffic type for each bonded interface.
7. Click Update to save the changes you made to the IP Address table. (Clicking Update
does not yet apply the new network settings to the ETERNUS CS800.)
8. Click Delete to remove IP address information for the selected interface. Or click Undo
to revert all current IP Address Table changes to the last update.
ETERNUS CS800
The IP address of the interface.
The network mask of the interface.
The gateway of the ETERNUS CS800. (This is usually not the same as
the default gateway.)
Select the check box if the IP address of the ETERNUS CS800 is
translated by a firewall to a NAT IP address when the ETERNUS
CS800 communicates to the outside world.
The IP address used to access the ETERNUS CS800 from the
public network. The router that connects the ETERNUS CS800 to
the Internet performs Network Address Translation that maps
the IP address of the ETERNUS CS800 to the NAT IP address,
providing a valid replication interface for a source ETERNUS
CS800.
Select to allow replication traffic.
Select to allow data traffic.
Select to allow all types of traffic (management, replication, and data).
6.3 Running the Getting Started Wizard
113