Table of Contents
Advertisement
1.2 Important Information
1.2.7
Modules with Electrostatic-Sensitive Devices
Modules with electrostatic-sensitive devices are identified by the following sticker:
Figure 1: ESD label
When you handle components fitted with ESDs, you must always observe the following
points:
Switch off the system and remove the power plugs from the power outlets before
l
installing or removing components with ESDs.
You must always discharge static build-up (e.g. by touching a grounded object) before
l
working with such components.
Any devices or tools that are used must be free of electrostatic charge.
l
Wear a suitable grounding cable that connects you to the external chassis of the system
l
unit.
Always hold components with ESDs at the edges or at the points marked green (touch
l
points).
Do not touch any connectors or conduction paths on an ESD.
l
Place all the components on a pad which is free of electrostatic charge.
l
For a detailed description of how to handle ESD components, see the relevant
European or international standards (EN 61340-5-1, ANSI/ESD S20.20).
1.2.8
Notes on Cleaning the Devices
CAUTION!
l
l
l
l
20
Switch the device off and disconnect the power plugs from the grounded
shock-proof sockets.
Do not clean any interior parts yourself; leave this job to a service technician.
Do not use any cleaning agents that contain abrasives or may corrode plastic.
Ensure that no liquid enters the system. Ensure that the ventilation areas of
the device are clear.
ETERNUS CS800
Advertisement
Table of Contents
