Procedure For E-Mail Send Test; Environment Configuration Using Wizard - Fujitsu ETERNUS DX60 Operation Manual

If the message has not been displayed, check the SNMP community name and SNMP Trap destination in the ETERNUS Disk storage
system settings. In addition, check that the network settings (e.g. firewall setting) is correct. Then, send the SNMP Trap on the ETERNUS
Web GUI again.

3.5.2 Procedure for E-mail Send Test

Check whether E-mail can be received at the specified E-mail address or SMTP server IP address.
Using the Web Console, check that the E-mail destination address is set up and then send test E-mail.
Refer to "Send Test E-mail" in the
Note
If an event notification E-mail destination address has been set, a test E-mail is sent to the E-mail destination address whether or
not an event notification E-mail has been set to send.
The test E-mail is sent only to the business administrator and system administrator.

3.6 Environment Configuration Using Wizard

Even without prior experience of ETERNUS Disk storage systems configuration and setup, the volume created in ETERNUS Disk storage
system can be assigned to the server with a wizard.
Express provides the following wizards:
Storage Configuration Wizard
This wizard can register new server and assign volumes created in ETERNUS Disk storage system to new server. In addition, volumes
to be assigned can be created in this wizard.
From "Main" of the Global Navigation tab or on the Action pane for "Storage", execute Configure Storage under Wizard.
Volume Allocation Wizard
This wizard can assign volumes created in ETERNUS Disk storage system to the registered server.
On "Main" of the Global Navigation tab or on the Action pane for "Storage", execute Assign Volume under Wizard.
Advanced Copy Configuration Wizard
This wizard can configure the copy table size and Snap Data Pool policy required for Advanced Copy operation.
Select ETERNUS Disk storage system from "Storage" of the Global Navigation tab and select "AdvancedCopy" on the Category pane.
Then, on the Action pane for "Configuration" on the Category pane for AdvancedCopy, execute AdvancedCopy under Wizard.
Wizard Name
Storage configuration wizard
Volume allocation wizard
ETERNUS SF Web Console Guide for details on the operation procedures.
1.
Register the server and add HBA
2.
Select ETERNUS Disk storage system to connect with the server
3.
Create RAID group (optional)
4.
Create volume (optional)
5.
Assign volume to the server
5-1. Register host
5-2. Create Affinity group
5-3. Add Host Affinity
1.
Select the server
2.
Select HBA and port
3.
Assign volume to the server
Flow of Operation
- 11 -