Mld Static-Group - HP 6125XLG Command Reference Manual

Blade switch ip multicast command reference
Table of Contents

Advertisement

Syntax
mld group-policy acl6-number [ version-number ]
undo mld group-policy
Default
No IPv6 multicast group filter is configured on an interface, and a host can join any IPv6 multicast group.
Views
Interface view
Predefined user roles
network-admin
Parameters
acl6-number: Specifies an IPv6 basic or advanced ACL by its number, in the range of 2000 to 3999. A
host can join only the IPv6 multicast groups that match the permit statement in the ACL. The source
addresses in the basic IPv6 rule are the IPv6 multicast group addresses specified in MLD reports. The
source and destination addresses specified in the IPv6 advanced ACL rule are IPv6 multicast source
addresses and multicast group addresses specified in MLD reports. The system assumes that 0::0 is the
multicast source address of an MLDv1 report or an MLDv2 IS_EX and TO_EX report that does not carry
an IPv6 multicast source address.
version-number: Specifies an MLD version number, 1 or 2. By default, the configured group filter is
effective for both MLDv1 reports and MLDv2 reports.
Usage guidelines
If you configure the interface as a static member interface for an IPv6 multicast group or an IPv6 multicast
source and group, this configuration has no effect on the IPv6 multicast group or the IPv6 multicast source
and group.
Examples
# Configure an IPv6 ACL so that hosts on VLAN-interface 100 can join the IPv6 multicast group
FF03::101 only.
<Sysname> system-view
[Sysname] acl ipv6 number 2005
[Sysname-acl6-basic-2005] rule permit source ff03::101 128
[Sysname-acl6-basic-2005] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld group-policy 2005

mld static-group

Use mld static-group to configure an interface as a static member of the specified IPv6 multicast group
or the specified IPv6 multicast source and group.
Use undo mld static-group to restore the default.
Syntax
mld static-group ipv6-group-address [ source ipv6-source-address ]
undo mld static-group { all | ipv6-group-address [ source ipv6-source-address ] }
140

Advertisement

Table of Contents
loading

Table of Contents