Igmp-Snooping Host-Aging-Time - HP 5900 Series Command Reference Manual

[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1
Related c ommands
group-policy (IGMP-snooping view)

igmp-snooping host-aging-time

Use igmp-snooping ho
Use undo igmp-snooping host-aging-time to restore the default.
Syntax
igmp-snoo ping host-aging-time interval
undo igmp -snooping host-aging-time
Default
The default setting is 260 seconds.
Views
VLAN view
Predefine d user roles
network-admin
Paramete rs
interval: Sets an aging timer for the dynamic member ports in a VLAN, in the range of 1 to 8097894
seconds.
Usage guide lines
You must enable IGMP snooping for a VLAN before you execute this command for the VL
To avoid mistakenly deleting multicast group members, set the aging timer for dynamic member ports to
be greater than the value calculated b
[ IG MP general query interval ] + [ maximum response time for IGMP general queries ]
HP recommends that you set the aging timer of dynamic member ports to the value calculated by the
following formula:
[ IGMP general query interva
This command and the host-aging-
different effective ran
The host-aging-time command in IGMP-snooping view
•
The ig mp-snooping host-aging-time command takes ef
•
For a VLAN, the igmp-snooping h
command in IGMP-snooping view.
Ex amples
# In VLAN 2, enable IGMP
seconds.
] igmp-snooping group-policy 2000 vlan 2
st-aging-time to set the aging timer for the dynamic member ports in a VLAN.
y the following formula:
l ] × 2 + [ maximum response time for IGMP general queries ]
time command in IGMP-snooping view have the same function but
ges:
ost-aging-time command takes priority over the host-aging-time
snooping, and set the aging timer for the dynamic member ports to 300
takes effect on all VLANs.
fect on the current VLAN.
25
AN.