D-Link xstack DGS-3620 series Reference Manual page 937

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<area_id> - Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain. This area is the transit area where the virtual link is
built.
<neighbor_id> - Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies
the OSPFv3 virtual neighbor in the OSPFv3 domain.
hello_interval - (Optional) Specifies to allow the specification of the interval between the
transmission of OSPFv3 Hello packets. The hello interval and dead interval should be the
same for all routers on the same link.
<sec 1-65535> - Enter the hello interval value used here. This value must be between 1 and
65535 seconds. The default value is 10 seconds.
dead_interval - (Optional) Specifies to allow the specification of the length of time between the
receipt of Hello packets from a neighbor router before the selected area declares that router
down. The Dead Interval must be evenly divisible by the hello interval.
<sec 1-65535> - Enter the dead interval value used here. This value must be between 1 and
65535 seconds. The default value is 60 seconds.
instance - (Optional) Specifies the instance ID on the virtual link.
<value 0-255> - Enter the instance ID value here. This value must be between 0 and 255. The
default value is 0.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To create OSPFv3 virtual link:
DGS-3620-28PC:admin# create ospfv3 virtual_link 1.1.1.1 60.60.60.60
Command: create ospfv3 virtual_link 1.1.1.1 60.60.60.60
Success.
DGS-3620-28PC:admin#
79-18 config ospfv3 virtual_link
Description
This command is used to configure an OSPFv3 virtual link.
Format
config ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | instance <value 0-255>} (1)
Parameters
<area_id> - Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain. This area is the transit area where the virtual link is
built.
<neighbor_id> - Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies
932