Chapter 42 Gratuitous Arp Commands - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 42
enable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
disable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
config gratuitous_arp learning [enable | disable]
config gratuitous_arp send dup_ip_detected [enable | disable]
config gratuitous_arp send ipif_status_up [enable | disable]
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
show gratuitous_arp {ipif <ipif_name 12>}
42-1 enable gratuitous_arp
Description
This command is used to enable the gratuitous ARP trap and log state. The switch can trap and
log the IP conflict event to inform the administrator.
Format
enable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
Parameters
ipif - (Optional) The interface name of the L3 interface.
<ipif_name 12> - Enter the interface name. The maximum length is 12 characters.
trap - Specifies trap. The trap is disabled by default.
log - Specifies log. The even log is enabled by default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the gratuitous ARP trap and log state:
DGS-3620-28PC:admin#enable gratuitous_arp ipif System trap log
Command: enable gratuitous_arp ipif System trap log
Success.
DGS-3620-28PC:admin#
42-2 disable gratuitous_arp
Description
This command is used to disable the gratuitous ARP trap and log state.
Gratuitous ARP
Commands
526