D-Link xstack DGS-3620 series Reference Manual page 1086

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
between 1 and 65535 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To configure the RIPng method as poison reverse:
DGS-3620-28PC:admin# config ripng method poison_reverse
Command: config ripng method poison_reverse
Success.
DGS-3620-28PC:admin#
95-5 config ripng ipif
Description
This command is used to specify the RIPng state and metric value for one or all interfaces
Format
config ripng ipif [<ipif_name 12> | all] {state [enable | disable] | metric <value 1-15>} (1)
Parameters
ipif - Specifies the RIPng IP interface name to be configured.
<ipif_name 12> - Enter the RIPng IP interface name to be configured here. This name can be
up to 12 characters long.
all - Specifies that all the RIPng IP interfaces will be used.
state - (Optional) Specifies the RIPng state of the specified IP interface.
enable - Specifies that the RIPng state on the specified interface will be enabled.
disable - Specifies that the RIPng state on the specified interface will be disabled.
metric - (Optional) Specifies the cost value of an interface. The RIPng route that was learned
from the interface will add this value as a new route metric.
<value 1-15> - Enter the metric value used here. This value must be between 1 and 15. The
default value is 1.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To enable the RIPng interface state:
1081