D-Link xstack DGS-3620 series Reference Manual page 595

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<list_name 16> - Specifies the name to identify the prefix list.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To creates one IP prefix list named 1:
DGS-3620-28PC:admin# create ip prefix_list 1
Command: create ip prefix_list 1
Success.
DGS-3620-28PC:admin#
49-2 config ip prefix_list
Description
This command defines the rule entry for an IP route prefix list.
A prefix list can have multiple rule entries; each is represented by a sequence number. The rule
with the lower sequence number will be evaluated first. If the sequence number is not specified for
the defined rule entry, the sequence number will be automatically given. The automatically given
sequence number will be a multiple of 5. Therefore, if the defined rule is the first rule in the prefix
list, the automatically given sequence number will be 5. If the defined rule is not the first rule in the
prefix list, the sequence number will be the number that is a multiple of 5 and larger than the
largest sequence number of an existing rule in the prefix list.
A prefix list consists of an IP address and a bit mask. The bit mask is entered as a number from 1
to 32. An implicit denial is applied to traffic that does not match any prefix list entry.
The IP route prefix list rule entry is defined to either permit or deny specific routes. Prefix lists are
configured to match an exact prefix length or a prefix range. The prefix list is processed using an
exact match when neither the ge nor le keyword is entered. If only the ge value is entered, the
range is the value entered for the ge ge-length argument to a full 32-bit length. If only the le value
is entered, the range is from the value entered for the network/length argument to the le le-length
argument. If both the ge ge-length and le le-length keywords and arguments are entered, the
range falls between the values used for the ge-length and le-length arguments.
The following formula is a restriction for the specified ge-length and le-length.
network/length < ge ge-length < le le-length <= 32
As an example, if the configured network address is 10.1.2.3/16, only the route 10.1.0.0/16 will
match the rule. The route 10.1.2.0/24 will not match the rule.
As another example, if 10.1.0.0/16 ge 24 is configured, then the route 10.1.0.0/16 will not match
the rule. The route 10.1.2.0/24 will match the rule. The route 10.1.2.3/32 will also match the rule.
590