D-Link xstack DGS-3620 series Reference Manual page 784

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<value 1-4> - Enter the mirror group ID used here. This value must be between 1 and 4.
target_port - (Optional) Specifies the port that will receive the packets duplicated at the mirror
port.
<port> - Enter the target port number used here.
add - (Optional) Specifies the mirror source ports to be add.
delete - (Optional) Specifies the mirror source ports to be delete
source - (Optional) Specifies the source ports used.
ports - (Optional) Specifies the list of ports used as source ports.
<portlist> - Enter the list of ports to be used as the source ports here.
vlan - (Optional) Specifies the VLANs that will be used as the source VLANs.
vlan_id - Specifies the VLAN ID that will be used as the source VLAN.
<vid_list> - Enter the VLAN ID list that will be used here. Note: This will be shared with
Ingress ACL entries.
rx - (Optional) Specifies that only the received packets on the mirror group source ports will be
mirrored to the mirror group target port.
tx - (Optional) Specifies that only the sent packets on the mirror group source ports will be
mirrored to the mirror group target port.
both - (Optional) Specifies that both the received and sent packets on the mirror group source
ports will be mirrored to the mirror group target port.
state - (Optional) Specifies the mirror group state to enable or disable the mirror group function.
enable - Specifies that the mirror group state will be enabled.
disable - Specifies that the mirror group state will be disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
Configure mirror group 2 with state enable and add source ports 1:4-1:9:
DGS-3620-28PC:admin# config mirror group_id 2 state enable add source ports
1:4-1:9 both
Command: config mirror group_id 2 state enable add source ports 1:4-1:9 both
Success.
DGS-3620-28PC:admin#
67-4 delete mirror group_id
Description
This command is used to delete a mirror group on the Switch.
Format
delete mirror group_id <value 1-4>
Parameters
<value 1-4> - Enter the mirror group ID used here. This value must be between 1 and 4.
779