D-Link xstack DGS-3620 series Reference Manual page 422

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<ipv6addr> - Specifies the source address of the entry which will be created into the Filter
DHCPv6 server forward list.
ports - Specifies the list of ports used for this configuration.
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all ports will be used for this configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a Filter DHCPv6 server permit entry on port 5:
DGS-3620-28PC:admin#create filter dhcpv6_server permit sip 2200::5 ports 1:5
Command: create filter dhcpv6_server permit sip 2200::5 ports 1:5
Success.
DGS-3620-28PC:admin#
24-6 config filter dhcpv6_server log
Description
This command is used to enable or disable the Filter DHCPv6 server log state.
Format
config filter dhcpv6_server log [enable | disable]
Parameters
enable - Specifies that the log for the Filter DHCPv6 server will be enabled. The log for Filter
DHCPv6 server will be generated.
disable - Specifies that the log for the Filter DHCPv6 server will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the Filter DHCPv6 Server log state:
DGS-3620-28PC:admin#config filter dhcpv6_server log enable
Command: config filter dhcpv6_server log enable
Success.
DGS-3620-28PC:admin#
417