D-Link xstack DGS-3620 series Reference Manual page 1196

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#
To display a specied IPv6 subnet VLAN entry:
DGS-3620-28PC:admin# show subnet_vlan ipv6network fe80:250:baff::0/64
Command: show subnet_vlan ipv6network fe80:250:baff::0/64
IP Address/Subnet Mask
------------------------
fe80:250:baff::0/64
DGS-3620-28PC:admin#
To display all subnet VLAN entries:
DGS-3620-28PC:admin#show subnet_vlan
Command: show subnet_vlan
IP Address/Subnet Mask
------------------------
172.168.1.1/255.255.255.0
172.18.211.1/255.255.255.0
172.18.211.6/255.255.255.0
fe80:250:baff::0/64
Total Entries: 4
DGS-3620-28PC:admin#
109-4 config vlan_precedence ports
Description
This command is used to configure vlan classification precedence on each port.
You can specify the order of MAC-based VLAN classification and subnet VLAN classification.
If a port's VLAN classification is MAC-based precedence, MAC-based VLAN classification will
process at first. If MAC-based VLAN classification fails, the subnet VLAN classification will be
executed.
If a port's VLAN classification is subnet VLAN precedence, the subnet VLAN classification will
process at first. If subnet VLAN classification fails, the MAC-based VLAN classification will be
executed.
Format
config vlan_precedence ports <portlist> [mac_based_vlan | subnet_vlan]
Parameters
<portlist> - Enter a list of ports used for this configuration here.
mac_based_vlan - Specifies that the MAC-based VLAN classification is precedence than subnet
VLAN classification
VLAN Priority
----- ----------
10 2
VLAN Priority
----- ----------
10 2
20 3
5 1
10 2
1191