D-Link xstack DGS-3620 series Reference Manual page 565

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#show router_ports vlan default
Command: show router_ports vlan default
VLAN Name
Static Router Port
Dynamic Router Port
Router IP
Forbidden Router Port
Total Entries: 1
DGS-3620-28PC:admin#
45-19 config igmp access_authentication ports
Description
This command is used to enable or disable the IGMP Access Control function for the specified
ports. If the IGMP Access Control function is enabled and the Switch receives an IGMP JOIN
message, the Switch will send the access request to the RADIUS server for authentication.
Format
config igmp access_authentication ports [all | <portlist>] state [enable {[auth_accounting |
auth_only | accounting_only]} | disable]
Parameters
all - Specifies all ports to be configured.
<portlist> - Enter a range of ports to be configured.
state - Specifies the state of the RADIUS authentication function on the specified ports.
enable - Enable the RADIUS authentication function on the specified ports.
auth_accounting - Specifies that after the client authenticated, accounting messages will
be sent to the RADIUS server. This is the default option.
auth_only - Specifies that after the client authenticated, accounting messages will not be
sent to the RADIUS server.
accounting_only - Specifies that authentication is not needed. If the client joins a group,
accounting messages will be sent to the RADIUS server.
disable - Disable the RADIUS authentication function on the specified ports.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable IGMP Access Control for all ports:
: default
:
:
:
:
560