D-Link xstack DGS-3620 series Reference Manual page 1051

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
To show the scheduling mechanism on ports 1-10:
DGS-3620-28PC:admin#show scheduling_mechanism 1-10
Command: show scheduling_mechanism 1-10
Port Mode
----- ------
1 Strict
2 Strict
3 Strict
4 Strict
5 Strict
6 Strict
7 Strict
8 Strict
9 Strict
10 Strict
DGS-3620-28PC:admin#
91-9 config 802.1p user_priority
Description
This command is used to configure the way by which the switch will map an incoming packet,
based on its 802.1p user priority, to one of the eight available hardware priority queues on the
switch. The switch's default is to map the following incoming 802.1p user priority values to the
eight hardware priority queues. The suggested mapping is shown in the following table. Users can
change this mapping by specifying the 802.1p user priority to assign to the <class_id>.
Priority in Frames
0
1
2
3
4
5
6
7
Format
config 802.1p user_priority {ports [<portlist> | all]} <priority 0-7> <class_id 0-7>
Parameters
ports - (Optional) Specifies that port used for this configuration.
portlist - Specifies the range of ports to be configured.
Priority Queue of ASIC
2
0
1
3
4
5
6
7
1046
Remark
Mid-Low
Lowest
Lowest
Mid-Low
Mid-High
Mid-High
Highest
Highest