D-Link xstack DGS-3620 series Reference Manual page 732

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin#show lldp ports 1
Command: show lldp ports 1
Port ID
--------------------------------------------------------------
Admin Status
Notification Status
Advertised TLVs Option
Port Description
System Name
System Description
System Capabilities
Enabled Management Address
(None)
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
DGS-3620-28PC:admin#
60-9 config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities
TLV is detected for an MSAP identifier not associated with an existing LLDP remote system MIB,
the application layer shall start the fast start mechanism and set the 'medFastStart' timer to
'medFastStartRepeatCount' times 1. The default value is 4.
Format
config lldp_med fast_start repeat_count <value 1-10>
Parameters
<value 1-10> - Enter a fast start repeat count value between 1 and 10. The default value is 4.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure a LLDP-MED fast start repeat count of 5:
: 1
: TX_and_RX
: Disabled
:
727
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled