D-Link xstack DGS-3620 series Reference Manual page 656

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
statically configured in ARP table, then the auto learned entry will not be created. If the entry is
statically configured on one port and the entry is auto-learned on another port, then the auto-
learned entry will not be created either.
Format
enable address_binding dhcp_snoop {[ipv6 | all]}
Parameters
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – (Optional) Specifies that all IP addresses will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the address binding DHCP snooping mode:
DGS-3620-28PC:admin#enable address_binding dhcp_snoop
Command: enable address_binding dhcp_snoop
Success.
DGS-3620-28PC:admin#
53-14 disable address_binding dhcp_snoop
Description
This command is used to disable address binding DHCP snooping. When DHCP snooping is
disabled, all of the auto-learned binding entries will be removed.
Format
disable address_binding dhcp_snoop {[ipv6 | all]}
Parameters
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – Specifies that all IP addresses will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the address binding DHCP snooping mode:
651