Chapter 79 Ospfv3 Commands - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 79
enable ospfv3
disable ospfv3
show ospfv3 {[ipif <ipif_name 12> | all]}
config ospfv3 router_id <ipaddr>
create ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
delete ospfv3 area <area_id>
config ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
show ospfv3 area {<area_id>}
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
delete ospfv3 aggregation <area_id> <ipv6networkaddr>
config ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
show ospfv3 aggregation {<area_id>}
show ospfv3 lsdb {area <area_id> | type [rtrlink | netlink | inter_area_prefix | inter_area_router |
asextlink | link_lsa | intra_area_prefix]}
show ospfv3 neighbor {<neighbor_id> ipif <ipif_name 12>}
show ospfv3 virtual_neighbor {<area_id> <neighbor_id>}
config ospfv3 [ipif <ipif_name 12> | all] {area <area_id> | priority <value 0-255> | hello_interval
<sec 1-65535> | dead_interval <sec 1-65535> | instance <value 0-255> | metric <value 1-
65535>| state [enable | disable] | passive [enable | disable]} (1)
create ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | instance <value 0-255>}
config ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | instance <value 0-255>} (1)
delete ospfv3 virtual_link <area_id> <neighbor_id>
show ospfv3 virtual_link {<area_id> <neighbor_id>}
79-1 enable ospfv3
Description
This command is used to enable OSPFv3 on the Switch.
Format
enable ospfv3
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
OSPFv3 Commands
917