D-Link xstack DGS-3620 series Reference Manual page 930

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To create an OSPFv3 area aggregation:
DGS-3620-28PC:admin# create ospfv3 aggregation 2.2.2.2 2000::/16 advertise
enable
Command: create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Success.
DGS-3620-28PC:admin#
79-10 delete ospfv3 aggregation
Description
This command is used to delete an OSPFv3 area aggregation.
Format
delete ospfv3 aggregation <area_id> <ipv6networkaddr>
Parameters
<area_id> - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address
that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
<ipv6networkaddr> - Specifies the IPv6 network address of the aggregation.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To delete an OSPFv3 area aggregation:
DGS-3620-28PC:admin# delete ospfv3 aggregation 2.2.2.2 2000::/16
Command: delete ospfv3 aggregation 2.2.2.2 2000::/16
Success.
DGS-3620-28PC:admin#
79-11 config ospfv3 aggregation
Description
This command is used to configure an OSPFv3 area aggregation.
925