D-Link xstack DGS-3620 series Reference Manual page 795

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<value 1-1000> - Enter the rate limit of MLD control packet that the switch can process on a
specific port/VLAN. The rate is specified in packet per second. The packet that exceeds the
limited rate will be dropped.
no_limit - The default setting is no limit.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the MLD snooping packet rate limit on port 1 for 100:
DGS-3620-28PC:admin#config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-3620-28PC:admin#
69-3 show mld_snooping rate_limit
Description
This command is used to display the MLD snooping rate limit setting.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specifies a range of ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
vlanid - Specifies a range of VLANs to be displayed.
<vlanid_list> - Enter the VLAN ID list.
Restrictions
None.
Example
To display the MLD snooping packet rate limit for ports 1 to 2:
DGS-3620-28PC:admin# show mld_snooping rate_limit ports 2:1-2:2
Command: show mld_snooping rate_limit ports 2:1-2:2
Port Rate Limit(pkt/sec)
-------- --------------------
2:1 No Limit
2:2 No Limit
790