D-Link xstack DGS-3620 series Reference Manual page 954

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ipif - (Optional) Specifies the name of the IP interface used to display the PIM configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display all the PIM configurations of all IP interfaces.
Restrictions
None.
Example
To display PIM configurations of IP interface System:
DGS-3620-28PC:admin# show pim
Command: show pim
PIM Global State
Last Hop SPT Switchover
Register Probe Time
Register Suppression Time : 60
PIM Interface Table
Interface IP Address
---------- ------------------ --------------- -------- -------- ----- --------
System 10.90.90.101/8
Total Entries : 1
DGS-3620-28PC:admin#
82-6 config pim cbsr
Description
This command is used to set the priority, hash mask length, and bootstrap period of the candidate
bootstrap (C-BSR) router per interface.
Format
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-255>]} | hash_masklen <value 0-
32> | bootstrap_period <value 1-255>]
Parameters
ipif - Specifies the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
priority - (Optional) Specifies to set the C-BSR priority. The lower value indicates lower priority.
The default value is -1. Note that only one interface can be the C-BSR in one device.
-1 - Specifies that the interface will be disable to be the BSR.
<value 0-255> - Enter the C-BSR priority value used here. This value must be between 0 and
: Enabled
: Never
: 5
Designated
Router
10.90.90.101
949
Hello J/P
Interval Interval Mode
35 70 DM
State
Enabled