D-Link xstack DGS-3620 series Reference Manual page 1247

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
rcp: - Specifies the path on the RCP server or local RCP client. Note: If a user specifies the
relative file path, the path search strategy will depend on the server system. For some
systems, the current user working directory will be searched first, followed by the environment
paths.
<string 128> - Enter the path on the RCP server or local RCP client.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id 1-12> - Enter the unit ID used here. This value must be between 1 and 12.
src_file - (Optional) Specifies the path name of the source file.
<pathname> - Enter the path name of the source file. Note that if no path name is specifies,
only the current device configuration will be uploaded.
include - (Optional) Includes lines that contain the specified filter string.
exclude - (Optional) Excludes lines that contain the specified filter string.
begin - (Optional) The first line that contains the specified filter string will be the first line of the
output.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol. Thus, the filter
string itself cannot contain the quotation mark character. The filter string is case sensitive.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol.
<filter_string 80> - Enter a filter string enclosed by the quotation mark symbol.
Restrictions
Only Administrators and Operators can issue this command.
Example
To upload the current configuration from the device to an RCP server:
DGS-3620-28PC:admin#upload cfg_toRCP username rcp_user 10.48.74.121 dest_file
/home/DGS-3620.cfg
Command: upload cfg_toRCP username rcp_user 10.48.74.121 dest_file /home/DGS-
3620.cfg
Connecting to server... Done.
Upload configuration... Done.
DGS-3620-28PC:admin#
119-7 upload firmware_toRCP
Description
This command is used to upload firmware from a device to a Remote Copy Protocol (RCP) server.
Format
upload firmware_toRCP [{username <username>} {<ipaddr>} dest_file <path_filename 64> |
rcp: <string 128>] {unit <unit_id 1-12>} {src_file <pathname>}
Parameters
username - (Optional) Specifies the remote user name on the RCP server.
<username> - Enter the remote user name on the RCP server.
<ipaddr> - (Optional) Specifies the IP address of the RCP server.
dest_file - Specifies the path name on the RCP server. Note: If a user specifies the relative file
1242