D-Link xstack DGS-3620 series Reference Manual page 681

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config jwac quarantine_server_error_timeout <sec 5-300>
Parameters
<sec 5-300> - Enter the error timeout interval.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the quarantine server error timeout:
DGS-3620-28PC:admin#config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DGS-3620-28PC:admin#
54-12 config jwac
Description
This command is used to configure the quarantine server URL. If the redirection is enabled and the
redirection destination is a quarantine server, when a HTTP request from an unauthenticated host
which is not headed to a quarantine server reaches the Switch, the Switch will handle this HTTP
packet and send back a message to the host to make it access the quarantine server with the
configured URL. When the PC connected to the specified URL, the quarantine server will request
the PC user to input the user name and password to authenticate.
Note: If the quarantine server is linked to the JWAC enabled port on the switch, it must
be added to the static FDB correctly before it can work properly.
Format
config jwac [quarantine_server_url <string 128> | clear_quarantine_server_url]
Parameters
quarantine_server_url - Specifies the entire URL of the authentication page on the quarantine
server.
<string 128> - Enter the entire URL of the authentication page on the quarantine server. The
quarantine server URL can be up to 128 characters long.
clear_quarantine_server_url - Specifies to clear the current quarantine server URL.
676