D-Link xstack DGS-3620 series Reference Manual page 977

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ipif - (Optional) Specifies the IP interface used.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display all neighbors learned by PIM6.
Restrictions
None. (EI Mode Only Command)
Example
To show the PIM6 neighbors:
DGS-3620-28PC:admin# show pim6 neighbor
Command: show pim6 neighbor
PIM6 Neighbor Address Table
Interface Neighbor Address
----------- ------------------
System FE80::11FF:4CD8
Total Entries : 1
DGS-3620-28PC:admin#
To show the PIM6 neighbors of interface "n20":
DGS-3620-28PC:admin# show pim6 neighbor ipif n20
Command: show pim6 neighbor ipif n20
Neighbor Info on Interface n20
----------------------------------------------------
Neighbor Address
Neighbor Up Time
Neighbor Expiry Time
Neighbor DR Priority Present
Neighbor DR Priority
Total Entries : 1
DGS-3620-28PC:admin#
83-12 show pim6 mroute
Description
This command is used to display the multicast routing info generated by the PIM6.
Format
show pim6 mroute {group <ipv6addr> {source <ipv6addr>}}
: FE80::11FF:4CD8
: 00:00:50
: 00:01:50
: True
: 1
972