D-Link xstack DGS-3620 series Reference Manual page 948

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the password recovery mode:
DGS-3620-28PC:admin# disable password_recovery
Command: disable password_recovery
Success.
DGS-3620-28PC:admin#
81-3 show password_recovery
Description
The command is used to display the password recovery state. The displayed content includes both
the running configuration and the NV-RAM configuration.
When the password recovery state is enabled a user can reboot the switch and enter into the
Password Recovery mode. Otherwise, if the Password Recovery state is disabled a user will not
be able to enter into the special recovery mode.
Note: Only the NV-RAM configuration will take effect when the switch restarts next time, the
running configuration does not take effect until saved. That means the password recovery is
determined by the state stored in the NV-RAM and take effect at the next time switch start up. The
Running Configuration is the current configured state of the password recovery, it will lost without
save, or become the NV-RAM configuration if save the configurations.
Format
show password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the password recovery state:
943