D-Link xstack DGS-3620 series Reference Manual page 557

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
45-9 config igmp_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress IGMP control packets.
Format
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specifies a range of ports to be configured.
<portlist> - Enter a range of ports to be configured.
vlanid - Specifies a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list.
<value 1-1000> - Enter the rate of IGMP control packets that the switch can process on a
specific port/VLAN. The rate is specified in packet per second. The packets that exceed the
limited rate will be dropped.
no_limit - The default setting is no limit.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the IGMP snooping rate limit for ports 1-2 to have no limit:
DGS-3620-28PC:admin#config igmp_snooping rate_limit ports 1-2 no_limit
Command: config igmp_snooping rate_limit ports 1-2 no_limit
Success.
DGS-3620-28PC:admin#
45-10 show igmp_snooping rate_limit
Description
This command is used to display the IGMP snooping rate limit setting.
Format
show igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specifies a range of ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
vlanid - Specifies a range of VLANs to be displayed.
<vlanid_list> - Enter the VLAN ID list.
552