Chapter 56 Lacp Configuration Commands - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 56
config lacp_port <portlist> {mode [active | passive] | lacp_timeout [short | long]}
show lacp_port {<portlist>}
56-1 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> {mode [active | passive] | lacp_timeout [short | long]}
Parameters
<portlist> - Enter a range of ports to be configured.
mode - (Optional) Specifies the port mode.
active - Specifies the mode as active.
passive - Specifies the mode as passive.
lacp_timeout - Specifies the LACP timeout mode.
short - Specifies that there will be 3 seconds before LACP invalidating received LACPDU
information and there will be 1 second between LACP PDU periodic transmissions when
using Short Timeouts.
long - Specifies that there will be 90 seconds before LACP invalidating received LACPDU
information and there will be 30 seconds between LACP PDU periodic transmissions when
using Long Timeouts.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure port LACP mode for ports 1 to 3:
DGS-3620-28PC:admin#config lacp_port 1-3 mode active
Command: config lacp_port 1-3 mode active
Success.
DGS-3620-28PC:admin#
56-2 show lacp_port
Description
This command is used to display per-port LACP mode.
LACP Configuration
Commands
696