D-Link xstack DGS-3620 series Reference Manual page 540

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
show igmp check_subscriber_source_network {ipif <ipif_name 12>}
Parameters
ipif – (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
If no parameter is specified, the system will display all interfaces.
Restrictions
None.
Example
To show the status of the check subscriber for the received IGMP report/leave messages on
interface "n20":
DGS-3620-28PC:admin# show igmp check_subscriber_source_network ipif n20
Command: show igmp check_subscriber_source_network ipif n20
Interface IP Address/Netmask
------------ ------------------
n20 20.1.1.1/8
Total Entries: 1
DGS-3620-28PC:admin#
To show the status of the check subscriber for the received IGMP report/leave messages on all
interfaces:
DGS-3620-28PC:admin# show igmp check_subscriber_source_network
Command: show igmp check_subscriber_source_network
Interface IP Address/Netmask
------------ ------------------
System 10.90.90.90/8
n1 1.1.1.1/8
n11 11.1.1.1/8
n20 20.1.1.1/8
n100 100.3.2.2/8
Total Entries: 5
DGS-3620-28PC:admin#
Check Subscriber Source Network
-------------------------------
Disabled
Check Subscriber Source Network
-------------------------------
Enabled
Disabled
Disabled
Disabled
Disabled
535