D-Link xstack DGS-3620 series Reference Manual page 756

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config loopback ipif <ipif_name 12> [{ipaddress <network_address> | state [enable |
disable]}(1)]
Parameters
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can be
up to 12 characters long.
ipaddress – (Optional) Specifies the IPv4 network address of the loopback interface.
<network_address> - Enter the IPv4 network address of the loopback interface here. It specifies
a host address and length of network mask.
state - (Optional) Specifies the state of the loopback interface.
enable - Specifies that the loopback interface state will be enabled.
disable - Specifies that the loopback interface state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the loopback interface named loopback1 with subnet address 10.0.0.1/8:
DGS-3620-28PC:admin# config loopback ipif loopback1 ipaddress 10.0.0.1/8
Command: config loopback ipif loopback1 ipaddress 10.0.0.1/8
Success.
DGS-3620-28PC:admin#
63-3 show loopback ipif
Description
This command is used to display the information of the loopback interface.
Format
show loopback ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) Enter the IP interface name used for this configuration here. This
name can be up to 12 characters long.
Restrictions
None.
751