Table of Contents
Advertisement
5. Perform the post-installation or maintenance steps required by the procedure that required the removal of
the access panel.
Remove the air baffle
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers,
or blanks installed. If the server supports hot-plug components, minimize the amount of time the access
panel is open.
Procedure
1. Remove the front bezel on page 39.
2. Power down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripherals cables from the server.
5. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
6. Do one of the following:
•
Server in tower mode: Position the tower server for hardware configuration on page 41.
•
Server in rack mode: Extend the server from the rack on page 43.
7. Remove the access panel on page 48.
8. While pressing the blue air baffle latches, lift up the baffle from the chassis.
50
Remove the air baffle
Advertisement
Table of Contents
