Table of Contents
Advertisement
•
Server in tower mode: Position the tower server for operation on page 42.
•
Server in rack mode: Slide the server into the rack on page 47.
18. Connect all peripheral cables to the server.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server on page 38.
22. Install the front bezel on page 40.
The installation is complete.
4 LFF hot-plug drive cage option
The server supports the 4 LFF drive cage option. This option:
•
Can be installed in boxes 1–3
•
Cannot be installed together with the 8 SFF hot-plug drive cage option
•
Supports SATA or SAS drives depending on the storage controller used
Kit contents
•
4 LFF hot-plug drive cage
•
LFF drive blanks (4, preinstalled in the drive cage)
•
Drive power cable
•
T-15 Torx screws (4)
Installing the 4 LFF hot-plug drive cage
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
Drive cage option kit
•
Storage controller cable option
•
LFF hot-plug drive option
•
T-15 Torx screwdriver
Procedure
1.
Remove the front bezel on page 39.
2.
Power down the server on page 38.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
•
Server in tower mode: Position the tower server for hardware configuration on page 41.
•
Server in rack mode: Extend the server from the rack on page 43.
6.
Remove the access panel on page 48.
7.
Remove the air baffle on page 50.
8.
If installed, remove the fan cage.
4 LFF hot-plug drive cage option
91
Advertisement
Table of Contents
