Table of Contents
Advertisement
The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit
easily into the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and
insert it again
11. If the fan cage was removed, do the following:
a. Make sure that all the system cables that are routed through the front cable channel are properly
secured in the metal cable tabs. This is done to prevent system damage due to cables being
inadvertently caught under the fan cage.
b. Install the fan cage on page 55
12. Install the air baffle on page 51.
13. Install the access panel on page 49.
14. Do one of the following:
•
Server in tower mode: Position the tower server for operation on page 42.
•
Server in rack mode: Slide the server into the rack on page 47.
15. Connect all peripheral cables to the server.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server on page 38.
19. Install the front bezel on page 40.
The installation is complete.
Processor heatsink assembly option
Installing the processor heatsink assembly
Procedure
1. Review the information about Intelligent System Tuning support for specific processors and configurations
from the product QuickSpecs on the server website at http://www.hpe.com/servers/ml350-gen10.
2. Identify the processor, heatsink, and socket module components.
3. Review the processor cautions.
4. Install the processor heatsink assembly.
Processor heatsink assembly option
113
Advertisement
Table of Contents
