Table of Contents
Advertisement
14. Make sure that the board is firmly seated in the slot.
15. Install the PCI blank retainer on page 58.
16. Observe the guidelines for managing cables.
17. Cable the controller.
18. If you are planning to install the Smart Storage Battery, install it now.
19. If the fan cage was removed, do the following:
a. Make sure that all the system cables that are routed through the front cable channel are properly
secured in the metal cable tabs. This is done to prevent system damage due to cables being
inadvertently caught under the fan cage.
b. Install the fan cage on page 55
20. Install the air baffle on page 51.
21. Install the access panel on page 49.
22. Do one of the following:
•
Server in tower mode: Position the tower server for operation on page 42.
•
Server in rack mode: Slide the server into the rack on page 47.
23. Connect all peripheral cables to the server.
24. Connect each power cord to the server.
25. Connect each power cord to the power source.
26. Power up the server on page 38.
27. Install the front bezel on page 40.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard
Enterprise website.
Smart Array modular controller option (AROC)
The server supports Smart Array Gen10 modular controller options (type-a, AROC). For more information on
the controller cable compatible with these modular controllers, see Storage controller cables on page 146.
118
Smart Array modular controller option (AROC)
Advertisement
Table of Contents
